Show Bootvar - Dell S6000 Reference Manual

show bootvar

Display the variable settings for the boot parameters.
S6000
Syntax
show bootvar
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.4
Version 8.3.11.1
Version 8.3.7.0
Version 7.5.1.0
E-Series
Example
Dell#show bootvar
PRIMARY IMAGE FILE =
SECONDARY IMAGE FILE =
DEFAULT IMAGE FILE =
LOCAL CONFIG FILE =
PRIMARY HOST CONFIG FILE =
SECONDARY HOST CONFIG FILE =
PRIMARY NETWORK CONFIG FILE =
SECONDARY NETWORK CONFIG FILE =
CURRENT IMAGE FILE =
CURRENT CONFIG FILE 1 =
CURRENT CONFIG FILE 2 =
CONFIG LOAD PREFERENCE =
BOOT INTERFACE GATEWAY IP ADDRESS =
Reload Mode =
Dell#
64
Introduced on the S6000.
Introduced on the S4820T.
Output expanded to display current reload mode (normal or
Jumpstart).
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series.
Original command.
system://B
tftp://10.16.127.35/Dell-SI-9-0-2-0.bin
system://A
variable does not exist
variable does not exist
variable does not exist
variable does not exist
system://B
flash://startup-config
variable does not exist
local first
normal-reload
variable does not exist
10.16.132.254
File Management