Displaying Show Sflow On A Stack-Unit; Configuring Specify Collectors; Changing The Polling Intervals - Dell S6100 Configuration Manual

Hide thumbs Also See for S6100:

Table of Contents

Configured sampling rate

Actual sampling rate

Counter polling interval

Extended max header size

Samples rcvd from h/w

The following example shows the show running-config interface command.

Dell#show running-config interface tengigabitethernet 1/1/6/1

interface TenGigabitEthernet 1/1/6/1

no ip address

sflow ingress-enable

sflow sample-rate 8192

Displaying Show sFlow on a Stack-unit

To view sFlow statistics on a specified Stack-unit, use the following command.

Display sFlow configuration information and statistics on the specified interface.

show sflow stack—unit slot-number

Example of Viewing sFlow Configuration (Line Card)

Dell#show sflow Stack-unit 1

Stack-unit 1

Samples rcvd from h/w

Total UDP packets exported

UDP packets exported via RPM

UDP packets dropped

The sflow collector command allows identification of sFlow collectors to which sFlow datagrams are forwarded.

You can specify up to two sFlow collectors. If you specify two collectors, the samples are sent to both.

Identify sFlow collectors to which sFlow datagrams are forwarded.

CONFIGURATION mode

sflow collector ip-address agent-addr ip-address [number [max-datagram-size number] ] | [max-

datagram-size number ]

The default UDP port is 6343.

The default max-datagram-size is 1400.

The sflow polling-interval command configures the polling interval for an interface in the maximum number of seconds between

successive samples of counters sent to the collector.

This command changes the global default counter polling (20 seconds) interval. You can configure an interface to use a different polling

To configure the polling intervals globally (in CONFIGURATION mode) or by interface (in INTERFACE mode), use the following command.

Change the global default counter polling interval.