Bgp Dmzlink-Bw - Dell Z9500 Command Reference Manual

Defaults 100
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage
All routers apply the bgp default local-preference command setting within
Information
the AS. To set the local preference for a specific route, use the set local-
preference command in ROUTE-MAP mode.
Related set local-preference
Commands

bgp dmzlink-bw

Enables BGP Link Bandwidth.
Z9500
Syntax
bgp dmzlink-bw
To disable BGP Link Bandwidth, enter the no bgp dmzlink-bw command.
Parameters
dmzlink-bw
Defaults N/A
Command ROUTER BGP
Modes
Command
Version
History
9.7(0.0)
376
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— assigns a local preference value for a specific route.
Enter the keyword dmzlink-bw to enable BGP Link
Bandwidth in BGP multipath.
Description
Introduced on the S-Series.
Border Gateway Protocol