Bgp Dmzlink-Bw - Dell C9000 Series Reference Manual

bgp dmzlink-bw

Enable BGP Link Bandwidth.
C9000 Series
Syntax
bgp dmzlink-bw
To disable BGP Link Bandwidth, enter the no bgp dmzlink-bw command.
Parameters
dmzlink-bw
Defaults N/A
Command Modes ROUTER BGP
Command History
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
Usage Information Configuring or un-configuring the command will bring down and bring up the BGP
Route Manager, this will result in tear down and re-establishment of all active sessions.
Link Bandwidth has to be configured on the router in order to tell it to associate Link
Bandwidth with prefixes (paths) and/or to use Link Bandwidth in BGP Multipath route
selection.
This is done under BGP configuration and is supported per address family – for IPv4
and IPv6 address families.
The configuration for a particular address family will apply across all VRFs configured.
This command must be performed on the router which is attaching link bandwidth to
prefixes (typically a border router) as well as the router which is expected to load share
traffic proportional to the bandwidth of the external links.
Enter the keyword dmzlink-bw to enable BGP Link Bandwidth
in BGP multipath.
Description
Introduced on the C9010 Series.
Introduced on the S3048–ON and S4048–ON.
Introduced on the S-Series.
Border Gateway Protocol 429