Table of Contents
Advertisement
To disable BFD sessions, use the following commands.
•
Disable BFD sessions with all IS-IS neighbors.
ROUTER-ISIS mode
no bfd all-neighbors
•
Disable BFD sessions with IS-IS neighbors on a single interface.
INTERFACE mose
isis bfd all-neighbors disable
Configure BFD for BGP
In a BGP core network, BFD provides rapid detection of communication failures in BGP fast-forwarding paths
between internal BGP (iBGP) and external BGP (eBGP) peers for faster network reconvergence. BFD for BGP is
supported on 1GE, 10GE, 40GE, port-channel, and VLAN interfaces. BFD for BGP does not support IPv6 and
the BGP multihop feature.
Prerequisites
Before configuring BFD for BGP, you must first configure the following settings:
1
Configure BGP on the routers that you want to interconnect, as described in
Border Gateway Protocol IPv4
2
Enable fast fall-over for BGP neighbors to reduce convergence time (the neighbor fall-over
command), as described in
Establishing Sessions with BGP Neighbors
Before configuring BFD for BGP, you must first configure BGP on the routers that you want to interconnect.
For more information, refer to
(BGPv4).
BGP Fast
Fall-Over.
Border Gateway Protocol IPv4
(BGPv4).
Bidirectional Forwarding Detection (BFD)
195
Advertisement
Table of Contents
Troubleshooting
