Bgp Recursive-Bgp-Next-Hop - Dell S6000 Reference Manual

compares MED between adjacent paths within an AS group because all paths in the
AS group are from the same AS.
When you change the path selection from Deterministic to Non-Deterministic, the
path selection for the existing paths remains Deterministic until you enter the
clear ip bgp command to clear existing paths.

bgp recursive-bgp-next-hop

Enable next-hop resolution through other routes learned by BGP.
S6000
Syntax
bgp recursive-bgp-next-hop
To disable next-hop resolution, use the no bgp recursive-bgp-next-hop
command.
Defaults Enabled
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.2.1.0
Usage
This command is a knob to disable BGP next-hop resolution using BGP learned
Information
routes. During the next-hop resolution, only the first route that the next-hop
resolves through is verified for the route's protocol source and is checked if the
route is learned from BGP or not.
The clear ip bgp command is required for this command to take effect and to
keep the BGP database consistent. Execute the clear ip bgp command right
after executing this command.
Border Gateway Protocol
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
343