Ip Ftp Vrf; Ip Telnet Server Enable - Dell S6000 Reference Manual

ip ftp vrf

Configures an FTP client with a VRF that is used to connect to the FTP server.
Syntax
ip ftp [vrf vrf-name]
To undo the FTP client configuration, use the ip ftp [vrf vrf-name]
command.
Parameters
vrf vrf-name
Defaults Disabled
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version 9.4.
(0.0)
Usage Use this command to make the FTP clients VRF aware. The VRF name that you
Information specify is used by the FTP client to reach the FTP server. If no VRF is specified, then
the default vrf is used.

ip telnet server enable

Enable the Telnet server on the switch.
S6000
Syntax
ip telnet server enable
To disable the Telnet server, use the no ip telnet server enable command.
Defaults Enabled
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
100
Enter the keyword vrf and then the name of the VRF to
specify the VRF that is used by the FTP client.
Introduced on the S-Series and Z-Series.
Control and Monitoring