Usage
You must also configure a password with the ip ftp password command.
Information
Related
ip ftp password
Commands
ip telnet server enable
Enable the Telnet server on the switch.
C-Series, E-Series, S-Series, Z-Series
Syntax
ip telnet server enable
To disable the Telnet server, use the no ip telnet server enable command.
Defaults
Enabled
Command Modes
CONFIGURATION
Command History
Version 8.3.11.1
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.1.1.0
Related
ip ssh server
Commands
ip telnet source-interface
Set an interface's IP address as the source address in outgoing packets for Telnet sessions.
C-Series, E-Series, S-Series, Z-Series
Syntax
ip telnet source-interface interface
To return to the default setting, use the no ip telnet source-interface
[interface] command.
Parameters
interface
126
– sets the password for FTP connections.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
– enables the secure shell (SSH) server on the system.
Enter the following keywords and slot/port or number information:
•
For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.