NEC Univerge sv8500 Manual page 1739

Fp85-110 s7
Hide thumbs Also See for Univerge sv8500:
Table of Contents

Advertisement

18.5.2 List of Maintenance Console Commands
Note:
DRS (Device Registration Server) used in this section refers to a control function of the Telephony
Server. Set the IP address of the Telephony Server (TP).
R: Required
C: Not required, but configurable
* If you go out of the configuration mode by using "logout" command without saving the setting information
using "reboot" command, the changed settings are discarded. To save the settings, execute "reboot" com-
mand, and exit the configuration mode.
* When you input a command, the current setting is displayed. If you change the setting, the changed data is
displayed. For "ipx_route" and "sip_route" commands, the changed settings and "Are you sure?" message
are displayed.
* Pressing the Enter key can skip each item.
SUB COMMAND
1
183rbt
2
184toprivacy
3
another_keynumber
4
auth
5
auth_header
6
call_hold
7
call_id_relay
8
cause_table
9
cc_convert
10
cdn_pattern
11
check_number
12
config_template
13
cpn_pattern
14
default
15
dnsaddress
16
domain
17
drsaddress
18
drs_qos
19
dtmf_mode
20
h245_base_port_no
set: Commands to Set Configuration Data
MUST?
Assigns whether to enable/disable local RBT when 183 message without SDP is
C
received.
Assigns whether to display/block the Caller ID to SIP network when dialing 184/
C
186.
Assigns additional three pilot numbers other than the one registered by "set
C
keynumber" command.
C
Assigns Digest authentication information.
C
Assigns whether to enable/disable the cache function of authentication header.
C
Assigns whether to enable/disable the MG based call retention.
C
Assign Call-ID notification function.
C
Assigns the error translation table.
C
Assigns calling party's country code display conversion feature.
C
Assigns called number pattern.
C
Assigns limit to the number of digits for calling/called party number.
R
Assigns the batch settings of Multipoint feature.
C
Assigns how to obtain cpn (calling party number)
C
Specifies default settings of the configuration.
C
Assigns the DNS IP address.
C
Specifies the DNS domain name.
R
Assigns the IP address and the port number of DRS server.
C
Specifies the DRS ToS.
C
Assigns a type of DTMF relay mode on the SIP network.
C
Assigns the base port number for H.245 TCP server.
VOL.2-1486
MG-SIP128 [MG-128SIPMGJ]
FUNCTION

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents