Cable Requirements For The Pt1000Ntc Thermistor; Fan Out 24 Vdc; Type K Thermocouples, Ch1 And Ch2 - Keysight PD1550A System Installation Manual

Accessory and Probe Installation

Cable Requirements for the PT1000NTC Thermistor

Keysight does not proved a cable for the PTC1000NTC Thermistor for PD1000A
Control Software version .
Figure 35 NTC Connector on Front of Test Fixture

Fan Out 24 VDC

An external fan is not available for PD1550A Initial Shipments.
Figure 36 24 V DC Fan Out Connector on Test Fixture Front

Type K Thermocouples, CH1 and CH2

Two type K thermocouples may be attached to the DUT for monitoring the
temperature during tests. How you create the thermocouples and attach them to
the DUT is up to you. The following information provides some general
guidelines.
78
+
Not Used
For early release versions of the PD1000A Control Software for the
PD1550A, this jack is not supported.
Install Additional Test Fixture Accessories
-
Keysight PD1550A Installation Guide