Actual Value Correction Configuration / Actval_Corr Conf; Actual Value Correction Status Word / Actval_Corr Status; Actual Value Correction Evaluation Factor Lsig / Actval_Cor Ev Lsig - Siemens SINAMICS G150 Manual

11
12
13
14
15
16
17
18
19
20
21
p1840[0...n]

Actual value correction configuration / ActVal_corr conf

VECTOR_G Can be changed: T
Data type: Unsigned16
P-Group: Modulation
Not for motor type: -
Min
-
Description: Sets the configuration of the actual value correction.
Bit field: Bit
00
01
Dependency: Refer to: p1802
Note: During operation (pulses enabled) the configuration cannot be changed by changing over drive data sets.
r1841

Actual value correction status word / ActVal_corr status

VECTOR_G Can be changed: -
Data type: Unsigned16
P-Group: Modulation
Not for motor type: -
Min
-
Description: Displays the status of actual value correction.
Bit field: Bit
00
01
02
03
14
15
p1845[0...n]

Actual value correction evaluation factor Lsig / ActVal_cor ev Lsig

VECTOR_G Can be changed: U, T
Data type: FloatingPoint32
P-Group: Modulation
Not for motor type: -
Min
0.00
Description: Sets the weighting factor for the leakage inductance of the L-R element of the actual value correction.
Dependency: Refer to: p0391, p0392, p0393
SINAMICS G130/G150
List Manual (LH2), 04/2014, A5E03263479A
Short-circuit test active
FL modulation prohibited
F3E present
Angle prerotation (advance) active in SW
Power unit with PS interface
Current measurement oversampling active
Actual value averaging temporarily
suppressed
Modulation depth limiting
Reduced DC link capacitance (without F3E) Yes
The setpoint is not reset
Voltage calibration active
Signal name
Actual value correction de-activated
Compares the integrals from modulator and
setpoint
Signal name
Hardware for the actual value correction
detected
Automatic shutdown (too many switching
instants)
Integral scaled to half the gating unit clock
cycle freq.
Actual value correction temporarily
suppressed
Reserved
Actual value correction active
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Calculated: -
Dyn. index: DDS, p0180
Units group: -
Scaling: -
Max
-
1 signal
Yes
Yes
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
-
1 signal
Yes
Yes
Yes
Yes
Yes
Yes
Calculated: -
Dyn. index: DDS, p0180
Units group: -
Scaling: -
Max
10.00
2 Parameters
2.2 List of parameters
Yes
No
No
No
No
No
No
No
No
No
No
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0000 bin
0 signal
No
No
Access level: 4
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
0 signal
No
No
No
No
No
No
Access level: 4
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
1.00
-
-
-
-
-
-
-
-
-
-
-
FP
-
-
FP
-
-
-
-
-
-
439