Motor Temperature Measured / Mot_Temp Meas; Encoder Diagnostics State Machine / Enc Diag Stat_Ma; Oem Encoder Diagnostic Signal Selection / Oem Enc Diag Sel - Siemens SINAMICS G150 Manual

2 Parameters
2.2 List of parameters
Note: This parameter is effective only when p0601 = 11.
PTC thermistor: Tripping resistance = 1650 Ohm
Information on using temperature sensors is provided in the following literature:
- hardware description of the appropriate components
- SINAMICS S120 Commissioning Manual
r4620[0...3]

Motor temperature measured / Mot_temp meas

VECTOR_G Can be changed: -
Data type: FloatingPoint32
P-Group: Displays, signals
Not for motor type: -
Min
- [°C]
Description: Displays the actual temperature in the motor measured through temperature channels 1 ... 4.
Index: [0] = Temperature channel 1
[1] = Temperature channel 2
[2] = Temperature channel 3
[3] = Temperature channel 4
Note: For a value not equal to -200.0 °C, the following applies:
- this temperature display is valid.
- a KTY sensor is connected.
For a value equal to -200.0 °C, the following applies:
- this temperature display is not valid (temperature sensor error).
- A PTC sensor or bimetallic NC contact is connected.
- the temperature sensor evaluation is de-activated (p0600 = 0 or p0601 = 0).
- the sensor channel is de-activated (p460x = 0 or p461x = 0).
r4640[0...95]

Encoder diagnostics state machine / Enc diag stat_ma

ENC, VECTOR_G Can be changed: -
Data type: Unsigned32
P-Group: Encoder
Not for motor type: -
Min
-
Description: Displays the encoder diagnostics for the PROFIdrive interface.
p4641[0...2]

OEM encoder diagnostic signal selection / OEM enc diag sel

VECTOR_G Can be changed: U, T
Data type: Unsigned16
P-Group: Encoder
Not for motor type: -
Min
0
Description: Trace functionality for OEM encoder manufacturers.
Index: [0] = Encoder 1
[1] = Encoder 2
[2] = Encoder 3
640
Calculated: -
Dyn. index: -
Units group: 21_1
Scaling: p2006
Max
- [°C]
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
65535
List Manual (LH2), 04/2014, A5E03263479A
Access level: 3
Func. diagram: -
Unit selection: p0505
Expert list: 1
Factory setting
- [°C]
Access level: 4
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
SINAMICS G130/G150