Drive Commissioning Parameter Filter / Drv Comm. Par_Filt; Bop Password Entry (P0013) / Bop Passw Ent P13; Bop Password Acknowledgement (P0013) / Bop Passw Ackn P13 - Siemens SINAMICS G150 Manual

p0010

Drive commissioning parameter filter / Drv comm. par_filt

VECTOR_G Can be changed: C2(1), T
Data type: Integer16
P-Group: -
Not for motor type: -
Min
0
Description: Sets the parameter filter to commission a drive.
Setting this parameter filters out the parameters that can be written into in the various commissioning steps.
Value: 0:
1:
2:
3:
4:
5:
15:
17:
25:
29:
30:
95:
10000: Ready with immediate feedback signal
Notice: For p0010 = 10000 the following applies:
After the value has been modified, no further parameter modifications can be made and the status is shown in r3996.
Modifications can be made again when r3996 = 0.
Note: The drive can only be powered up outside the drive commissioning (inverter enable). To realize this, this parameter
must be set to 0.
By setting p3900 to a value other than 0, the quick commissioning is completed, and this parameter is automatically
reset to 0.
Procedure for "Reset parameter": Set p0010 to 30 and p0970 to 1.
p0010 = 10000 corresponds to p0010 = 0. Unlike with p0010 = 0, the parameter modification is applied immediately
and the calculations are made in the background. Further parameter modifications cannot be made while the
calculations are being performed.
p0011

BOP password entry (p0013) / BOP passw ent p13

CU_G130_DP, Can be changed: U, T
CU_G130_PN,
Data type: Unsigned16
CU_G150_DP,
P-Group: Functions
CU_G150_PN
Not for motor type: -
Min
0
Description: Sets the password for the Basic Operator Panel (BOP).
Dependency: Refer to: p0012, p0013
p0012

BOP password acknowledgement (p0013) / BOP passw ackn p13

CU_G130_DP, Can be changed: U, T
CU_G130_PN,
Data type: Unsigned16
CU_G150_DP,
P-Group: Functions
CU_G150_PN
Not for motor type: -
Min
0
Description: Acknowledges the password for the Basic Operator Panel (BOP).
Dependency: Refer to: p0011, p0013
SINAMICS G130/G150
List Manual (LH2), 04/2014, A5E03263479A
Ready
Quick commissioning
Power unit commissioning
Motor commissioning
Encoder commissioning
Technological application/units
Data sets
Basic positioner commissioning
Position control commissioning
Only Siemens int
Parameter reset
Safety Integrated commissioning
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
10000
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
65535
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
65535
2 Parameters
2.2 List of parameters
Access level: 1
Func. diagram: 2800, 2818
Unit selection: -
Expert list: 1
Factory setting
1
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
43