Tm150 Commissioning Parameter Filter / Tm150 Com Par_Filt; Tm31 Commissioning Parameter Filter / Tm31 Comm Par_Filt; Tm54F Commissioning Parameter Filter / Tm54F Com Par_Filt - Siemens SINAMICS G150 Manual

2 Parameters
2.2 List of parameters
p0010

TM150 commissioning parameter filter / TM150 com par_filt

TM150 Can be changed: C2(1), T
Data type: Integer16
P-Group: -
Not for motor type: -
Min
0
Description: Sets the parameter filter for commissioning a Terminal Module 150 (TM150).
Setting this parameter filters out the parameters that can be written into in the various commissioning steps.
For the BOP, this setting also causes the read access operations to be filtered.
Value: 0:
29:
30:
Dependency: Refer to: p0970
Note: Only the following values are possible: p0010 = 0, 30
Procedure for "Reset parameter": Set p0010 to 30 and p0970 to 1.
p0010

TM31 commissioning parameter filter / TM31 comm par_filt

TM31 Can be changed: C2(1), T
Data type: Integer16
P-Group: -
Not for motor type: -
Min
0
Description: Sets the parameter filter for commissioning a Terminal Module 31 (TM31).
Setting this parameter filters out the parameters that can be written into in the various commissioning steps.
For the BOP, this setting also causes the read access operations to be filtered.
Value: 0:
29:
30:
Dependency: Refer to: p0970
Note: Only the following values are possible: p0010 = 0, 30
Procedure for "Reset parameter": Set p0010 to 30 and p0970 to 1.
p0010

TM54F commissioning parameter filter / TM54F com par_filt

TM54F_MA Can be changed: C2(1), T
Data type: Integer16
P-Group: -
Not for motor type: -
Min
0
Description: Sets the parameter filter for commissioning a Terminal Module 54F (TM54F).
Setting this parameter filters out the parameters that can be written into in the various commissioning steps.
For the BOP, this setting also causes the read access operations to be filtered.
Value: 0:
29:
30:
95:
Dependency: Refer to: p0970
Note: Procedure for "Reset parameter": Set p0010 to 30 and p0970 to 1.
42
Ready
Only Siemens int
Parameter reset
Ready
Only Siemens int
Parameter reset
Ready
Only Siemens int
Parameter reset
Safety Integrated commissioning
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
30
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
30
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
95
List Manual (LH2), 04/2014, A5E03263479A
Access level: 1
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 1
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 1
Func. diagram: 2847
Unit selection: -
Expert list: 1
Factory setting
0
SINAMICS G130/G150