Power Unit Components Active/Inactive / Pu Comp Act/Inact; Power Unit Eeprom Data Version / Pu Eeprom Version; Power Unit Firmware Version / Pu Fw Version - Siemens SINAMICS G150 Manual

2 Parameters
2.2 List of parameters
Notice: It is not permissible to de-activate drive objects with safety functions enabled.
Note: The activation of a component can be rejected if the component was inserted for the first time. In this case, it is only
possible to activate the component when the pulses for all of the drive objects are inhibited.
For units connected in parallel, when one of the power units is de-activated, then the enable in p7001 is withdrawn.
Re value = 0, 2:
When a component is deactivated it no longer outputs any errors.
If value = 0:
The component was completely commissioned and is deactivated using this value. It can be removed from the
DRIVE-CLiQ without any error.
If value = 1:
The component must be available for error-free operation.
If value = 2:
A component in a project generated offline and set to this value must never be inserted in the actual topology from
the very start. This means that the component is marked to be bypassed in the DRIVE-CLiQ line.
For components that comprise several individual components (e.g. Double Motor Modules), it is not permissible to
set just one subset to this value.
r0126[0...n]

Power unit components active/inactive / PU comp act/inact

B_INF, VECTOR_G Can be changed: -
Data type: Integer16
P-Group: Data sets
Not for motor type: -
Min
0
Description: Displays the "active/inactive" state of a power unit component.
Value: 0:
1:
Dependency: Refer to: p0105, p0125, p0897
r0127[0...n]

Power unit EEPROM data version / PU EEPROM version

B_INF, VECTOR_G Can be changed: -
Data type: Unsigned32
P-Group: Converter
Not for motor type: -
Min
-
Description: Displays the version of the EEPROM data of the power unit.
Dependency: Refer to: r0147, r0157
Note: For parallel circuit configurations, the parameter index is assigned to a power unit.
r0128[0...n]

Power unit firmware version / PU FW version

B_INF, VECTOR_G Can be changed: -
Data type: Unsigned32
P-Group: Converter
Not for motor type: -
Min
-
Description: Displays the firmware version of the power unit.
Dependency: Refer to: r0018, r0148, r0158, r0197, r0198
Note: Example:
The value 1010100 should be interpreted as V01.01.01.00.
For parallel circuit configurations, the parameter index is assigned to a power unit.
88
Component inactive
Component active
Calculated: -
Dyn. index: PDS, p0120
Units group: -
Scaling: -
Max
1
Calculated: -
Dyn. index: PDS, p0120
Units group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: PDS, p0120
Units group: -
Scaling: -
Max
-
List Manual (LH2), 04/2014, A5E03263479A
Access level: 2
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
SINAMICS G130/G150