Power Unit Firmware Properties 2 / Pu Fw Property 2; Vsm Properties / Vsm Properties - Siemens SINAMICS G150 Manual

2 Parameters
2.2 List of parameters
17
18
19
20
21
22
23
24
25
26
27
28
29
30
Dependency: Refer to: r0193
Notice: This information represents the characteristics/features of the power unit firmware. It does not provide
information/data about the characteristics/features of the hardware (e.g. bit 06 = 1 means that although the firmware
supports "liquid cooling", a power unit with liquid cooling does not have to be used).
Note: Re bit 09:
The Motor Module supports the internal armature short-circuit. The function is internally required for voltage
protection (p1231 = 3).
Re bit 10:
The Motor Module supports the autonomous internal voltage protection.
If the "internal voltage protection" function is activated (p1231 = 3) the Motor Module decides autonomously - using
the DC link voltage - as to whether the short-circuit is activated.
Re bit 23:
The component supports the detection of current actual values (and the detection of valve close durations) with
double clocking and phase shift.
r0193

Power unit firmware properties 2 / PU FW property 2

B_INF, VECTOR_G Can be changed: -
Data type: Unsigned32
P-Group: Converter
Not for motor type: -
Min
-
Description: Displays the properties supported by the power unit firmware.
Bit field: Bit
01
Dependency: Refer to: r0192
r0194[0...n]

VSM properties / VSM properties

VECTOR_G Can be changed: -
Data type: Unsigned32
P-Group: Encoder
Not for motor type: -
Min
-
Description: Displays the properties supported by the Voltage Sensing Module (VSM).
Bit field: Bit
00
98
Compound braking possible
Extended voltage range possible
Gating unit available with current limitation
control
Component status possible
Temperature evaluation via Motor Module /
CU terminals possible
Reduced device supply voltage possible
Current measurement oversampling
available
Parking keeping the relevant data is
available
Internal fan operating hours counter
available
Software gating unit supported in the
Control Unit
Current controller dynamics higher
Reserved
Voltage measurement
Gating unit with all-phase current limiting
Signal name
Component trace
Signal name
Reserved
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
-
1 signal
Yes
Calculated: -
Dyn. index: p0150
Units group: -
Scaling: -
Max
-
1 signal
Yes
List Manual (LH2), 04/2014, A5E03263479A
No
No
No
No
No
No
No
No
No
No
No
No
No
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
0 signal
No
Access level: 4
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
0 signal
No
SINAMICS G130/G150
-
-
-
-
-
-
-
-
-
-
-
-
-
-
FP
-
FP
-