Parameter Values - Siemens SINAMICS G150 Manual

Table 2-5
Table 2-6

Parameter values

Min
Max
Factory setting
Note
For SINAMICS G130/G150, the macros and their settings are provided in the following
documentation:
References: /BAx/
SINAMICS G130/G150
List Manual (LH2), 04/2014, A5E03263479A
Unit groups (p0505), continued
Unit group
1
2
22_2 m/s
23_1 Vrms s/m
24_1 Ns/m
24_2 Ns/m
3
26_1 m/s
2
39_1 1/s
49_1 Nm/rad
Unit group (p0595)
Unit group
9_1 The values that can be set and the technological units are shown in p0595.
Minimum value of the parameter [unit]
Maximum value of the parameter [unit]
Value when delivered [unit]
In the case of a binector/connector input, the signal source of the
default BICO interconnection is specified. A non-indexed
connector output is assigned the index [0].
A different value may be displayed for certain parameters
(e.g. p1800) at the initial commissioning stage or when establishing
the factory settings.
Reason:
The setting of these parameters is determined by the operating
environment of the Control Unit (e.g. depending on converter type,
macro, power unit).
x = 1, 2
SINAMICS G150/G130 Operating Instructions
Unit selection for p0505 =
2 3
2
% ft/s
Vrms s/m Vrms s/ft
Ns/m lbf s/ft
% lbf s/ft
3 3
m/s ft/s
2
% 1/s
% lbf ft/rad
Unit selection for p0595 =
Value
2.1 Overview of parameters
Reference variable for %
4
% p2007
Vrms s/ft -
lbf s/ft -
% p2003/p2000
3
ft/s -
% p2007
% p2003
Reference variable for %
Unit
2 Parameters
27