Si Motion User Agreement Selection/De-Selection Mm; Si Motion User Agreement Inside The Drive Mm / Si Mtn Useragr Int; Co/Bo: Si Safety Info Channel Status Word S_Zsw2B / Sic S_Zsw2B; Si Message Buffer Changes, Counter / Si Msg_Buffer Chng - Siemens SINAMICS G150 Manual

p9740 SI Motion user agreement selection/de-selection MM / SI mtn UserAgr MM
VECTOR_G Can be changed: U, T
Data type: Integer16
P-Group: Safety Integrated
Not for motor type: -
Min
0000 hex
Description: Setting to select and de-select the user agreement on the Motor Module/Hydraulic Module.
Value: 0:
172:
Dependency: Refer to: r9741
r9741

SI Motion user agreement inside the drive MM / SI Mtn UserAgr int

VECTOR_G Can be changed: -
Data type: Integer16
P-Group: Safety Integrated
Not for motor type: -
Min
-
Description: Displays the internal state of the user agreement.
Value = 0: User agreement is not set.
Value = AC hex: User agreement is set.
Dependency: Refer to: p9740
r9743.4...15

CO/BO: SI Safety Info Channel status word S_ZSW2B / SIC S_ZSW2B

VECTOR_G Can be changed: -
Data type: Unsigned16
P-Group: Safety Integrated
Not for motor type: -
Min
-
Description: Display and BICO output for status word S_ZSW2B of the safety information channel.
Bit field: Bit
04
07
08
09
12
13
14
15
Note: SIC: Safety Info Channel
r9744

SI message buffer changes, counter / SI msg_buffer chng

VECTOR_G Can be changed: -
Data type: Unsigned16
P-Group: Messages
Not for motor type: -
Min
-
Description: Displays the changes of the safety message buffer.
This counter is incremented every time that the safety message buffer changes.
SINAMICS G130/G150
List Manual (LH2), 04/2014, A5E03263479A
[00 hex] De-select user agreement
[AC hex] Select user agreement
Signal name
SLP selected position area
SLP selected and user agreement set
SDI positive selected
SDI neg selected
Test stop active
Test stop required
Reference position required
Reference trigger command identified or
reference position valid
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
00AC hex
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
-
1 signal
SLP2
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Calculated: -
Dyn. index: -
Units group: -
Scaling: -
Max
-
2 Parameters
2.2 List of parameters
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0000 hex
Access level: 3
Func. diagram: 2822
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
0 signal
SLP1
No
No
No
No
No
no
no
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
FP
-
-
-
-
-
-
-
-
925