Siemens SINAMICS G150 Manual page 470

2 Parameters
2.2 List of parameters
r2050[0...3] CO: IF1 PROFIdrive PZD receive word / IF1 PZD recv word
ENC Can be changed: -
Data type: Integer16
P-Group: Communications
Not for motor type: -
Min
-
Description: Connector output to interconnect PZD (setpoints) with word format received from the fieldbus controller.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
Dependency: Refer to: r2060
Notice: Where there is a multiple interconnection of a connector output, all the connector inputs must either have Integer or
FloatingPoint data types.
A BICO interconnection for a single PZD can only take place either on r2050 or r2060.
Note: IF1: Interface 1
r2050[0...4] CO: IF1 PROFIdrive PZD receive word / IF1 PZD recv word
TB30, TM150, TM31 Can be changed: -
Data type: Integer16
P-Group: Communications
Not for motor type: -
Min
-
Description: Connector output to interconnect PZD (setpoints) with word format received from the fieldbus controller.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
Note: IF1: Interface 1
r2050[0...31] CO: IF1 PROFIdrive PZD receive word / IF1 PZD recv word
VECTOR_G Can be changed: -
Data type: Integer16
P-Group: Communications
Not for motor type: -
Min
-
Description: Connector output to interconnect PZD (setpoints) with word format received from the fieldbus controller.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
[8] = PZD 9
[9] = PZD 10
[10] = PZD 11
[11] = PZD 12
[12] = PZD 13
[13] = PZD 14
[14] = PZD 15
470
Calculated: -
Dyn. index: -
Units group: -
Scaling: 4000H
Max
-
Calculated: -
Dyn. index: -
Units group: -
Scaling: 4000H
Max
-
Calculated: -
Dyn. index: -
Units group: -
Scaling: 4000H
Max
-
List Manual (LH2), 04/2014, A5E03263479A
Access level: 3
Func. diagram: 2440, 2468
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: 2440, 2468
Unit selection: -
Expert list: 1
Factory setting
-
SINAMICS G130/G150