Stack-Unit Provision - Dell S4810 Reference Manual

Version 8.3.7.0
Version 8.3.11.1
Version 7.7.1.0
Related
•
Commands

stack-unit provision

Preconfigure a logical stacking ID of a switch that joins the stack. This is an optional command that is
executed on the management unit.
S4810
Syntax
stack-unit [stack-unit] provision {S25N|S25P|S25V|S50N|S50V|
Z9000|S4810|S4820T}
Parameters
stack-unit
S25N|S25P|
S25V|S50N|
S50V|Z9000|
S4810|S4820T
Defaults When this value is not set, a switch joining the stack is given the next available
sequential stack member identifier.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 8.3.11.1
Version
8.3.19.0
Version 8.3.7.0
Version 7.7.1.0
Related
•
Commands
Stacking
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the S-Series.
reload – reboots Dell Networking OS.
Enter a stack member identifier of the switch that you want
to add to the stack.
Enter the model identifier of the switch to be added as a
stack member. This identifier is also referred to as the
provision type.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series.
reload – reboots Dell Networking OS.
1615