Storm-Control Unknown-Unicast (Interface) - Dell S4810 Reference Manual

Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
Version 6.5.1.0
Usage Unknown Unicast Storm-Control is valid for Layer 2 and Layer 2/Layer 3 interfaces.
Information

storm-control unknown-unicast (Interface)

Configure percentage of unknown-unicast traffic allowed on an interface (ingress only).
S4810
Syntax
storm-control unknown-unicast [percentage decimal_value in] |
[wred-profile name]] [packets_per_second in]
To disable unknown-unicast storm control on the interface, use the no storm-
control unknown-unicast [percentage decimal_value in] | [wred-
profile name]] [packets_per_second in] command.
Parameters
percentage
decimal_value
[in | out]
Storm Control
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
E-Series Only: Added the percentage decimal value
option.
Introduced on the E-Series.
E-Series Only: Enter the percentage of broadcast traffic
allowed in or out of the network. Optionally, you can
designate a decimal value percentage, for example, 55.5%.
The percentage is from 0 to 100:
• 0% blocks all related traffic.
1627