Downstream - Dell S4810 Reference Manual

downstream

Assign a port or port-channel to the uplink-state group as a downstream interface.
S4810
Syntax
downstream interface
To delete an uplink-state group, enter the no downstream interface
command.
Parameters
interface
Defaults none
Command UPLINK-STATE-GROUP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version
8.3.19.0
Version
8.3.12.0
Version 8.4.2.3
Uplink Failure Detection (UFD)
Enter one of the following interface types:
• Fast Ethernet: fastethernet {slot/port | slot/
port-range}
• 1 Gigabit Ethernet: gigabitethernet {slot/port |
slot/port-range}
• 10 Gigabit Ethernet: tengigabitethernet {slot/
port |slot/port-range}
• Port channel: port-channel {1-512 | port-
channel-range}
Where port-range and port-channel-range specify a
range of ports separated by a dash (-) and/or individual
ports/port channels in any order; for example:
gigabitethernet 1/1-2,5,9,11-12 port-channel
1-3,5. A comma is required to separate each port and port-
range entry.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series S50.
1679