Tunnel Allow-Remote - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

of the far end tunnel peer, rather than to the tunnel destination. This reduces the

chance of both ends of the tunnel staying in keepalive down state. If both ends get

into a keepalive down state that does not clear in a few seconds, then performing

shutdown - no shutdown sequence on one end should bring both ends back to

tunnel allow-remote

Configure an IPv4 or IPv6 address or prefix whose tunneled packets are accepted for decapsulation. If

you do not configure allow-remote entries, tunneled packets from any remote peer address is accepted.

tunnel allow-remote {ip-address | ipv6-address} [mask]

To delete a configured allow-remote entry use the no tunnel allow-remote

command. Any specified address/mask values must match an existing entry for the

delete to succeed. If the address and mask are not specified, this command deletes

all allow-remote entries.

ipv6–address

If you do not configure tunnel allow remote , all traffic which is destined to tunnel

source address is decapsulated.

INTERFACE TUNNEL

Version 9.4(0.0)

You can configure up to eight allow-remote entries on any multipoint receive-only

This command fails if the address family entered does not match the outer header

address family of the tunnel mode, tunnel source, or any other tunnel allow-

If you configure any allow-remote , the tunnel source or tunnel mode commands

fail if the outer header address family does not match that of the configured allow-

Enter the source IPv4 address in A.B.C.D format.

Enter the source IPv6 address in X:X:X:X::X format.

(OPTIONAL) Enter a network mask in /prefix format (/x) or

A.B.C.D to match a range of remote addresses. The default

mask is /32 for IPv4 addresses and /128 for IPv6 addresses,

which match only the specified address.

Introduced on the S4810, S4820T, S6000 and Z9000.