Bpdu-Destination-Mac-Address - Dell S4810 Reference Manual

pre-Version
6.2.1.1

bpdu-destination-mac-address

Use the Provider Bridge Group address in Spanning Tree or GVRP PDUs.
S4810
Syntax
bpdu-destination-mac-address [stp | gvrp] provider-bridge-group
Parameters
xstp
gvrp
Defaults The destination MAC address for BPDUs is the Bridge Group Address.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.2.1.0
debug spanning-tree
Enable debugging of the spanning tree protocol and view information on the protocol.
S4810
Syntax
debug spanning-tree {stp-id [all | bpdu | config | events |
exceptions | general | root] | protocol}
To disable debugging, use the no debug spanning-tree command.
1630
Introduced on the E-Series.
Force STP, RSTP, and MSTP to use the Provider Bridge Group
address as the destination MAC address in its BPDUs.
Forces GVRP to use the Provider Bridge GVRP Address as the
destination MAC address in its PDUs.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Spanning Tree Protocol (STP)