Policy Action Maximum Bandwidth - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

Hide thumbs Also See for OmniSwitch 6250:

Table of Contents

policy action maximum bandwidth

Configures a maximum bandwidth value for a policy action.

policy action action_name maximum bandwidth bps

policy action action_name no maximum bandwidth

Syntax Definitions

Platforms Supported

OmniSwitch 6250

Usage Guidelines

Use the no form of the command to remove a maximum bandwidth value from an action.

Note that the bandwidth may be entered in bits per second. Alternatively, the bandwidth may be

entered in abbreviated units (1k, 2k, etc). If the bandwidth value is entered in bytes, the switch rounds

the value to the nearest thousand bytes. For example, if you enter 1 to 1024, the result is 1K. If you

enter 1025 to 2048, the result is 2K.

-> policy action action4 maximum bandwidth 10000

-> policy action action4 maximum bandwidth 10k

-> policy action action4 no maximum bandwidth

Release History

Release 6.6.1; command was introduced.

The name of the action.

The desired value for maximum bandwidth, in bits per second. The

value may be entered as an integer (for example, 10000) or with abbre-

viated units (for example, 10k). If the value is entered in bits per second,

the switch rounds the value up to the nearest thousand.

OmniSwitch CLI Reference Guide

QoS Policy Commands

November 2009