Table of Contents
Advertisement
Chapter 4 Operation and Control
mA-3011 Network Configuration
mA-3011 Network Mode
The procedures in this section describe how to configure the mA-3011 network settings
using the Web UI.
The mA-3011 network settings can also be configured using the Chassis Web UI. Refer to
the mA-1302/mA-1305 AXIe Operation Manual for instructions to configure the mA-3011
network mode of operation using the Chassis Web UI.
NOTE
When the mA-3011 Network Mode is changed, the current Web Browser UI connection
will be lost. A new Web Browser connection will need to be established with the updated
mA-3011 IP Address.
Configure Network Using Web UI
The procedures in this section require the mA-3011's IP Address. If you do not know the
mA-3011's IP Address, see
Set Module to Use a Static IP Address
1
Power on the CMP System.
2
Open a web browser window.
3
Enter the mA-3011 IP address in the browser window URL field.
4
Navigate to the mA-3011 Networking page (see
page
5
Select the module instrument slot and set the module Network Mode to Static.
–
6
Enter desired IP address for the mA-3011.
7
Select the Apply button.
8
At user prompt, select the Apply and Reply button.
NOTE
The system will initiate an auto reboot sequence that takes approximately 10 to
15 seconds. If the system does not auto reboot within one minute, press the Power
On/Standby button and refer to the following:
•
If the Power On/Standby button turns green, the system has initiated the reboot
sequence. Wait while the system completes the power up process.
•
If the Power On/Standby button turns yellow, the system failed to initiate the power
on sequence. Press the Power On/Standby button again to initiate the power on
sequence and wait while the systems completes the power up process.
Page 4-6
"Locate mA-3011 IP Address" on page
5-5).
Module Network Mode menu: Slots section of the Network Settings Table
mA-3011 AXIe Embedded Host Module Operation Guide
4-5.
"CPUC Networking Page" on
Rev. C0
May 2020
Advertisement
Table of Contents
