Table of Contents
Advertisement
Configuration
4
CONFIGURATION
14/59
After connecting the fiber to be tested to the optical
connector, you must select the Nano-OSA module (see
the Base Unit user manual).
To configure the Base Unit in preparation for an OSA test
on a fiber, press the SETUP button. Two configuration
procedures are available:
•
"Auto-set mode"
In this case the parameters are selected automatically.
•
"Manual configuration"
In this case you may define your own configuration.
Auto-set mode
◮ Press the Auto-set softkey.
Following configuration will automatically be set.
Parameter
Acquisition settings
Sweep
Measurements setting
Channel detection
Signal threshold
Splitter compensation
Results screen settings
Grid
Channel Width
Alarms
Unit of x-axis
In case of any parameter setting the Test Auto WDM
softkey appears.
Setting
Single
All
Auto
No
conventional
Auto
No
last setting used (THz or nm)
Nano-OSA user manual
Advertisement
Table of Contents
