Xerox WorkCentre 5687 Series Service Manual page 1738

PL 7.15 HCF Tray 3 and 4 Assembly (1
of 2)
Item Part Description
1 022E27180 Tray hoist pulley
2 050K59433 Tray 4 assembly (NOTE) (REP 7.2)
3 050K59422 Tray 3 assembly (NOTE) (REP 7.2)
4 – Front short elevator cable (P/O PL
7.15 Item 10, 11)
5 – Rear elevator cable (tray 4) (P/O
PL 7.15 Item 11)
6 – Rear elevator cable (tray 3) (P/O
PL 7.15 Item 10)
7 – Front long elevator cable (P/O PL
7.15 Item 10, 11)
8 – HCF (complete)
9 130K67521 Tray 3 feed sensor actuator (REP
8.14)
10 012K05690 Tray 3 elevator cable assembly
(REP 7.4)
11 012K05701 Tray 4 elevator cable assembly
(REP 7.4)
12 849E21140 Pulley carrier
13 – (Not used)
14 004K07330 Tray 4 elevate damper assembly
(REP 7.11)
15 004K07320 Tray 3 elevate damper assembly
(REP 7.11)
16 038E30370 Tray lift guide
17 019E73940 Cork pad
18 – Separation strip (7 off) (P/O PL 7.15
Item 19)
19 – Separation strip kit (P/O PL 31.13
Item 13)
20 – Paper tray guide (P/O PL 7.15 Item
2, 3) (ADJ 7.1)
21 807E22950 Gear (REP 7.11)
22 – Retard clip assembly (P/O PL 7.15
Item 23)
23 – Tray 4 multifeed kit (P/O PL 31.12
Item 4)
24 801E11400 Corner separation strip
25 019E75120 Metamoll Pad
NOTE: Refer to ADJ 7.1 to set the tray 3 and tray 4 paper
guides.
Parts Lists
PL 7.15
August 2007
5-26 WorkCentre 5687 Family