Xerox WorkCentre 5687 Series Service Manual page 1763

PL 9.15 Developer Assembly (65-87
ppm)
Item Part Description
1 094K05020 Toner dispense module (P/O PL
31.12 Item 21) (REP 9.5)
2 – Developer module (P/O PL 31.12
Item 23) (REP 9.2)
3 – Retaining bracket (P/O PL 9.15
Item 1)
4 – Toner cartridge (P/O PL 26.11 Item
2) (NOTE 1)
5 – Low toner sensor (Q09-310) (P/O
PL 9.15 Item 13)
6 – Registration/Developer bias
harness (Not Spared)
7 – Toner concentration sensor (Q09-
360) (P/O PL 9.15 Item 2)
8 – Toner Cartridge latch (P/O PL 9.15
Item 24)
9 – Retaining plate (P/O PL 9.15 Item
2)
10 – Speed nut (P/O PL 9.15 Item 2)
11 – Sleeve (P/O PL 9.15 Item 24)
12 – Not used
13 – Out of toner sensor kit (P/O PL
31.13 Item 8)
14 – Push on fastener (P/O PL 9.15 Item
24)
15 – Spring (P/O PL 9.15 Item 24)
16 807E09950 Main drive gear (P/O PL 9.15 Item
23) (ADJ 4.1)
17 – Not used
18 – Not used
19 – Trickle outlet shutter kit (P/O PL
31.12 Item 3)
20 – Shutter assembly (P/O PL 9.15
Item 19)
21 – Shutter spring (P/O PL 9.15 Item
19)
22 – Push on fastener (P/O PL 9.15 Item
19)
23 – Developer/Drives interface kit (P/O
PL 31.13 Item 12) (NOTE 2)
24 – Developer latch repair kit (P/O PL
31.12 Item 2)
NOTE: A waste toner bottle, PL 9.10 Item 1 is supplied with
the toner cartridges.
NOTE: The main drive gear PL 9.15 Item 16 and developer
drive gear/pulley PL 4.12 Item 17, must always be replaced
as a pair.
WorkCentre 5687 Family
August 2007
5-51
Parts Lists
PL 9.15