11-170-170, 11-172-170 HCSS BM Exit Jam RAP
11-170-170 The lead edge of a sheet is late arriving at the BM paper present sensor.
11-172-170 The trail edge of a sheet is late leaving the BM paper present sensor.
Initial Actions
•
If necessary, remove any paper from the BM.
•
Check that there is no damage or obstruction in the booklet compiling area or the paper
path to the booklet compiling area.
•
Check that the stapler bracket assembly, PL 11.88 Item 10 is correctly latched.
•
Check the operation of the BM tampers, refer to the 11-066-170, 11-384-170 HCSS BM
Tamper Failure RAP. If the tampers are operating correctly, go to ADJ 11.5-170 Booklet
Tamping and check the tampers are correctly adjusted.
Procedure
Lower the stapler bracket assembly, Figure 1. Enter dC330 code 11-190 BM paper present
sensor, Q11-190. Actuate Q11-190. The display changes.
Y
N
Go to Flag 1. Check Q11-190.
Refer to:
•
GP 11, How to Check a Sensor.
•
P/J556, BM PWB.
•
11C-170 HCSS BM Power Distribution RAP.
Install new components as necessary:
•
BM paper present sensor, PL 11.88 Item 5.
•
BM PWB, PL 11.86 Item 10.
Go to Flag 1. Check the connectors and harness between PJ568 and P/J556. Refer to GP 7.
The wiring and connectors are good.
Y
N
Repair the wiring, REP 1.2 or install new components as necessary.
11-170 Only: Enter dC330 code 11-060 BM compiler motor, MOT11-060. MOT11-060 runs.
Y
N
Go to Flag 2. Check MOT11-060.
Refer to:
•
GP 10 How to Check a Motor.
•
P/J554, BM PWB.
•
11C-170 HCSS BM Power Distribution RAP.
Install new components as necessary
•
BM compiler motor, PL 11.86 Item 1.
•
BM PWB, PL 11.86 Item 10.
11-170 Only: Unlatch the entrance baffle assembly, PL 11.80 Item 22. Run again MOT11-060.
The BM entry roll rotates.
WorkCentre 5687 Family
Y
N
Check the following components:
•
BM compiler motor belt, PL 11.86 Item 15.
•
BM entry roll pulley, PL 11.80 Item 14.
•
BM entry roll, PL 11.80 Item 15.
Install new components as necessary.
11-172 Only: Make a 60 page booklet (15 sheets of paper). Check that the top sheet of paper
has not been torn from the booklet. The booklet is good.
Y
N
Check that the components in the lower crease roll gear and clutch assembly are cor-
rectly installed. Refer to the replacement procedure in REP 11.52-170 BM Crease Rolls,
Gears and Bearings.
Perform SCP 6 Final Actions.
August 2007
2-491
Status Indicator RAPs
11-170-170, 11-172-170