Toyota Tundra 2005 Service - Repair - Maintenance page 2210

CH−14
SST (C)
SST (C)
Turn
SST (B)
Push
CHARGING (2UZ−FE)
(d)
(e)
P04210
(f)
(g)
SST (A)
P04395
(h)
Turn
SST (A)
P13598
5.
Inside
(a)
NOTICE:
Be careful of the rubber insulators installation direction.
B05860
(b)
B12750
− GENERATOR (Standard Spec.)
Mount SST (C) in a vise.
Insert SST (B) into SST (C), and attach the pulley nut to
SST (C).
To torque the pulley nut, turn SST (A) in the direction
shown in the illustration.
Torque: 110.5 N·m (1,125 kgf·cm, 81 ft·lbf)
Remove the generator from SST (C).
Turn SST (B), and remove SST (A and B).
INSTALL RECTIFIER HOLDER
Install the 4 rubber insulators on the lead wires.
Install the rectifier while pushing it with the 4 screws.
Torque: 1.96 N·m (20 kgf·cm, 17 in.·lbf)