Fefd Disable; Fefd Interval - Dell Z9500 Reference Manual

Related
•
Commands
•
•

fefd disable

Disable FEFD on an interface only. This command overrides the fefd reset command for the interface.
Z9500
Syntax
fefd disable
To re-enable FEFD on an interface, use the no fefd disable command.
Defaults Not configured.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
Usage When you enter no fefd for an interface and fefd-global, FEFD is enabled on the
Information interface because the no fefd command is not retained in the configuration file.
To keep the interface FEFD disabled when the global configuration changes, use
the fefd reset command.
Related
•
Commands
•

fefd interval

Set an interval between control packets.
Z9500
Syntax
fefd interval seconds
To return to the default value, use the no fefd interval command.
Layer 2
fefd disable — disables far-end failure detection on an interface.
fefd reset — enables FEFD globally on the system.
fefd mode — changes FEFD mode on an interface.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
fefd reset — enables FEFD globally on the system.
fefd mode — changes FEFD mode on an interface.
1133