Related
•
Commands
•
fefd interval
Set an interval between control packets.
S4810
Syntax
fefd interval seconds
To return to the default value, use the no fefd interval command.
Parameters
seconds
Defaults
15 seconds
Command
INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Legacy E-
Series
command.
Related
•
Commands
fefd mode
Change the FEFD mode on an interface.
S4810
Syntax
fefd mode {normal | aggressive}]
To return the FEFD mode to the default of normal, use the no fefd mode
command.
1070
fefd reset
— enables FEFD globally on the system.
fefd mode
— changes FEFD mode on an interface.
Enter a number as the time between FEFD control packets.
The range is from 3 to 300 seconds. The default is 15
seconds.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
fefd
— enables far-end failure detection.
Layer 2