Table of Contents
Advertisement
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\802.1X.fm
Default Configuration
Protect
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The command is relevant for single-host mode.
The command is not relevant for multiple-hosts mode.
The command is relevant for multiple-sessions mode, but you should note
that since PCs are sending traffic prior to successful 802.1X authentication,
this command might not be useful in this mode.
BPDU message whose MAC address is not the supplicant MAC address
wouldn't be discarded in the protect mode.
BPDU message whose MAC address is not the supplicant MAC address
would cause a shutdown in the shutdown mode.
Example
console(config)# interface gigabitethernet gi1/0/1
console(config-if)# dot1x violation-mode protect
dot1x guest-vlan
Use the dot1x guest-vlan Interface Configuration (VLAN) mode command to
define a guest VLAN. Use the no form of this command to restore the default
configuration.
Syntax
dot1x guest-vlan
no dot1x guest-vlan
Default Configuration
No VLAN is defined as a guest VLAN.
D E L L C O N F I D E N T I A L – P R E L I M I N A R Y 5 / 1 5 / 1 2 - F O R P R O O F O N LY
315
802.1x Commands
Advertisement
Table of Contents
