Dot1X Guest-Vlan - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

dot1x authentication (Configuration)

dot1x guest-vlan

Configure a guest VLAN for limited access users or for devices that are not 802.1X capable.

dot1x guest-vlan vlan-id

To disable the guest VLAN, use the no dot1x guest-vlan vlan-id command.

Not configured.

CONFIGURATION (conf-if-interface-slot/port)

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 9.0.0.0

Version 8.3.11.1

Version 7.6.1.0

1X authentication is enabled when an interface is connected to the switch. If the

host fails to respond within a designated amount of time, the authenticator places

the port in the guest VLAN.

If a device does not respond within 30 seconds, it is assumed that the device is not

802.1X capable. Therefore, a guest VLAN is allocated to the interface and

authentication, for the device, occurs at the next reauthentication interval (dot1x

reauthentication).

— Enable dot1x globally.

Enter the VLAN Identifier. The range is from 1 to 4094.

Introduced on the S6000.

Introduced on the Z9000.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the Z9000.

Introduced on the C-Series, E-Series, and S-Series.