Dot1X Guest-Vlan - Dell C9000 Series Reference Manual

Usage Information The dot1x critical-vlan command configures critical VLAN for the interface. If
the authentication server is not reachable or not responding, the authenticator places
the port or the supplicant in critical VLAN within the first attempt.
Use this command in Interface Batch mode to configure critical VLAN for users in a
dual-homing setup.
Example
Dell(conf)#show dot1x interface ten gigabit ethernet 0/41
802.1x information on Te 0/41:
-----------------------------
Dot1x Status:
Port Control:
Port Auth Status:
Re-Authentication:
Untagged VLAN id:
Guest VLAN:
Guest VLAN id:
Auth-Fail VLAN:
Auth-Fail VLAN id:
Auth-Fail Max-Attempts:
Critical VLAN:
Critical VLAN id:
Mac-Auth-Bypass:
Mac-Auth-Bypass Only:
Tx Period:
Quiet Period:
ReAuth Max:
Supplicant Timeout:
Server Timeout:
Re-Auth Interval:
Max-EAP-Req:
Host Mode:
Auth PAE State:
Backend State:

dot1x guest-vlan

Configure a guest VLAN for limited access users or for devices that are not 802.1X capable.
C9000 Series
Syntax
dot1x guest-vlan vlan-id
To disable the guest VLAN, use the no dot1x guest-vlan vlan-id command.
Parameters
vlan-id
Enable
AUTO
AUTHORIZED (CRITICAL-VLAN)
Enable
400
Enable
400
Enable
400
3
Enable
400
Disable
Disable
30 seconds
60 seconds
2
30 seconds
30 seconds
60 seconds
2
SINGLE_HOST
Authenticated
Idle
Enter the VLAN Identifier. The range is from 1 to 4094.
802.1X 246