System Registration Adjustment; Tray 5 Guide Adjustment - Xerox workcentre 5335 series Service Manual

System Registration Adjustment

NOTE: For details on System Registration see adjustment
Initial Issue
WorkCentre 5335 Family Service Documentation

Tray 5 Guide Adjustment

Purpose
ADJ 9.10.
This procedure calibrates the paper size detection circuits for Tray 5. It should be performed
when the tray 5 size sensor is replaced or a size detection error occurs
Procedure
1.
2.
3.
4.
5.
6.
7.
07/2011
6-7
BUS Updated 12/2011
Enter UI Diagnostic mode (Accessing UI Diagnostics).
Select Registration on the Maintenance/Diagnostics screen.
Select Tray 5 Guide Adjustment
Push the paper guides to their minimum width.
Select the Minimum Size Position radio button, then press Start.
Push the paper guides to their maximum width.
Select the Maximum Size Position radio button, then press Start.
System Registration Adjustment, Tray 5 Guide Ad-
General Procedures & Information