Xerox workcentre 5335 series Service Manual page 1416

Chain-
Link Component Description
077-071 Duplex Drive Motor Drives Duplex Drive Motor with 2 phase excitation. max. speed. (Pull-in direction)
078-003 HCF Feed Motor: Feed Drives the Motor in the Feed direction at a frequency of 2320PPS (307.5mm/s).
078-004 HCF Feed Motor: Lift Drives the Motor in the Lift direction at a frequency of 3395PPS (450mm/s).
Drives it only when HCF Tray Level Sensor is Off.
Stops driving it if the sensor turns On while it is driving.
Does not drive it when HCF Tray In Sensor is Off.
078-093 HCF T/A Motor Drives HCF T/A Roll at a speed of 330 mm/s.
091-001 BCR AC Bias Enable the output of BCR AC Bias
091-002 BCR DC Bias Enable the output of BCR DC Bias
091-003 BCR AC/DC Bias Simultaneous output of BCR AC Bias, BCR DC Bias
091-004 BCR AC/DC Bias + Dev. Simultaneous output of BCR AC Bias, BCR DC Bias and Dev. DC Bias
DC Bias
091-005 BCR AC/DC Bias + Dev. Simultaneous output of BCR AC Bias, BCR DC Bias, Dev. DC Bias, and Drum Motor On
DC Bias + Drum Motor
093-001 Dev. DC Bias Dev DC output Output value: NVM (Deve-DC I/O Check output value)
093-002 Dispense Motor Output of Dispense Motor
094-001 BTR (-) Outputs the BTR Bias (-).
094-002 BTR (+) Outputs the BTR Bias (+).
094-003 DTS Outputs the Detack Bias
General Procedures & Information
Component Control
Table 2 Output Component Control List - IOT/IIT/DADF/HCF
07/2011
6-20
BUS Updated 12/2011
Time-out conflicts
078-004
078-003
- 091-003,004,005
- 091-003,004,005
- 091-001, 002,004,005
- 091-001, 002,003,005; 093-001
- 091-001, 002,003,004; 093-001;
042-001, 002
- 091-004, 091-005
-
- 094-002
- 094-001
-
WorkCentre 5335 Family Service Documentation
Initial Issue