Delete All Data
Purpose
This procedure deletes user-defined/registered information and information recorded automat-
ically by the system from the hard disk, the Controller (ESS) NVM PWB and Buffer RAM.
This procedure also Initializes Sys System, IOT NVM, and IIT NVM resulting in loss of the fac-
tory setups for System Registration, Image Quality and the Scanner setups.
Procedure
1.
Enter UI Diagnostic mode
(Accessing UI
2.
Select Delete All Data.
3.
Select Start.
4.
A confirmation message appears. Select Delete.
5.
The Deleting data... message appears.
6.
When the message indicating the completion appears, exit UI Diagnostic mode, Switch
off the power, then switch on the power.
Initial Issue
WorkCentre 5335 Family Service Documentation
CAUTION
Diagnostics).
BUS Updated 12/2011
Initialize NVM
Procedure
1.
Enter UI Diagnostic mode
(Accessing UI
for the following subsystems appear:
•
IOT
•
Output (Finisher)
•
IISS (IIT/IPS)
•
IISS-Extension
•
Input Device
•
Sys-SYSTEM
•
Sys-USER
2.
Select the subsystem to be initialized and select Start.
All NVM for the selected subsystem will be reset to the default values. Any machine-specific,
region-specific, or customer-specific information will need to be re-entered. Make sure that this
information is available before proceeding.
3.
A confirmation message appears. Select Yes.
4.
A message indicating completion will appear.
5.
Select the Confirm button.
This completes the initialization. Remember to re-enter any machine-specific NVM data.
NOTE: For a complete listing of accessible NVM locations, refer to the NVM Tables in the
Library section
07/2011
6-13
Diagnostics). Select Initialize NVM. Selections
CAUTION
General Procedures & Information
Delete All Data, Initialize NVM