Xerox workcentre 5335 series Service Manual page 1418

Chain-Link Component Description
012-013 Sub Paddle Solenoid Sub Paddle rotation
012-014 Sub Paddle Rotation Sub Paddle makes one rotation.
(Rotates Transport Motor FORWARD at the same time as Sub Paddle Solenoid turns ON.)
012-017 Set Clamp Motor Set Clamp Motor rotates forward.
012-020 Front Tamper Mot Low Front Tamper moves to Front at low speed.
Front
012-021 Front Tamper Mot Mid- Front Tamper moves to Front at medium speed.
dle Front
012-022 Front Tamper Mot Front Tamper moves to Front at high speed.
High Front
012-023 Front Tamper Mot Low Front Tamper moves to Rear at low speed.
Rear
012-024 Front Tamper Mot Mid- Front Tamper moves to Rear at medium speed.
dle Rear
012-025 Front Tamper Mot Front Tamper moves to Rear at high speed.
High Rear
012-026 Rear Tamper Mot Low Rear Tamper moves to Front at low speed.
Front
General Procedures & Information
Component Control
Table 4 Output Component Control Codes - Integrated Office Finisher
07/2011
6-22
BUS Updated 12/2011
Time-out conflicts
660ms 012-014
Mot: 3162 012-013
Sol: 660ms 012-095
012-096
012-097
250 pulses 012-061
100 pulses 012-021
012-022
012-023
012-024
012-025
100 pulses 012-020
012-022
012-023
012-024
012-025
100 pulses 012-020
012-021
012-023
012-024
012-025
100 pulses 012-020
012-021
012-022
012-024
012-025
100 pulses 012-020
012-021
012-022
012-023
012-025
100 pulses 012-020
012-021
012-022
012-023
012-024
100 pulses 012-027
012-028
012-029
012-030
012-031
WorkCentre 5335 Family Service Documentation
Initial Issue