Marker Search; Auto Analysis - Keysight N9923A FieldFox User Manual

 Then choose from the following:
 Then
 Enter a value in dBm for the marker using the numeric keypad, the ▲|▼ arrows,
 Press
 Then choose from the following:

Marker Search

Use Marker Search to find and move markers to locations on the Tr 1 trace.
How to Search with Markers
 Activate the marker to be used for the search
 Then press Mrk ->/Tools.
 Then
 Then
 Then choose from the following:
Then choose from the following:
 Target, Peak, and Minimum. Learn more about these standard features


NOTE Rise and Fall time in Marker Search uses different criteria than in Auto Analysis and
will therefore result in different reported values.

Auto Analysis

Auto Analysis reports the following TEN pulse measurements:
Pulse Measurements Mode - Option 330
Amplitude markers are NOT displayed.
OFF
o
Amplitude markers ARE displayed at their previous positions.
ON
o
Ampl Mkr 1 or 2
or the rotary knob.
Delta AmplMkr
AmplMkr 2 value is relative to AmplMkr 1. When AmplMkr 1 is moved,
ON
o
AmplMkr 2 also moves to maintain the AmplMkr 2 value between them.
The two amplitude markers move independent of one another.
OFF
o
Marker Search
Zone Search
Available ONLY when the zoom window is enabled, the search is limited to
ON
o
the zone defined by the zoom window.
The search is performed over the entire Tr 1 trace.
OFF
o
beginning on page 114.
Select, then set a value in dB. Delta markers are created and placed
Rise Time
at the Peak and at the specified value BEFORE the Peak.
Select, then set a value in dB. Delta markers are created and placed at
Fall Time
the Peak and at the specified value AFTER the Peak.
1 - Average Power Average power level of all measured data points
2 - Peak Power Highest reading of all measured data points
99