Data Out Of Range; Two Entries Already Exist At This X-Axis Value - Keysight X-Series Manual

Instrument Messages
Event Messages
Err# Message
-222
Data out of range; Two
entries already exist
at this x-axis value.
-222
Data out of
range;Calibration Date
(YYYYMMDD) is invalid
-223
Too much data
-223
Too much data; 200
spurs found.
Additional spurs
ignored.
-224
Illegal parameter
value
-224
Illegal parameter
value; <Value>
invalid. Fractional
values are not
allowed.
-224
Illegal parameter
value; <value> out of
range.
-224
Illegal parameter
value; Cannot set
waveform to continue
previous waveform on
the first step
-224
Illegal parameter
value; EMI Avg/RMS Avg
and Average detector
can't be used together
-224
Illegal parameter
value; Exceeding the
max list length
-224
Illegal parameter
value; existing Screen
Name not found
-224
Illegal parameter
value; Gated FFT is
not available while
Sweep Type is set to
Swept
Instrument Messages
Verbose/Correction Information
When entering values for limit lines, you cannot have more than two
y-axis (amplitude) values entered for a specific x-axis (frequency)
value.
You have entered an invalid calibration date. The calibration date
should be in the format of YYYYMMDD.
A data element (of block, expression, array type, or string type) had
more data then allowed by the command, or by the available memory.
There are too many spurs for the table (the limit is 200), and any
additional spurs that are found will be ignored.
An exact data value (from a list of the allowed values) was required -
but not found. See the feature description for information about the
expected parameter values.
The seconds parameter of an LXI time may not contain a fractional
portion. For example 123456789.0 is valid while 123456789.1 is not.
The value does not fall in the valid range
An attempt was made to set the waveform for the first step in a
sequence to "Continue Previous" while there is no previous waveform
to continue playing back.
User is not allowed to turn on any EMI Avg/RMS Avg and Average
detector together. They are always mutually exclusive.
The list parameters have a maximum allowed length. You are trying to
set a length longer than the maximum.
An attempt was made to reference an existing Screen Name, but the
text provided did not match an existing Screen Name.
The gated FFT function is not available if you have selected the swept
type of sweep. You must be in the FFT sweep type.
74