Remote Interface Configurations; Usb - Keysight EPM Series Installation Manual

Remote Interface Configurations

The power meter can be remotely controlled by LAN, USB, and GPIB (IEEE488)
programming interfaces. This section shows you how to set the interface
configurations.
Only one interface should be used at any one time.
To connect the power meter to your PC, configure and verify your connection,
NOTE
you can use the Keysight IO Libraries Suite, the E2094M Keysight IO Libraries for
Windows, or an equivalent.
– Keysight IO Libraries Suite for Windows 98/2000/ME/XP. For information and
– E2094M Keysight IO Libraries for Windows 98/NT/2000/ME/XP. You can find
– You can also access other information about Keysight IO Libraries at
For more information on configuring the remote interface connectivity, refer to the
Keysight Technologies USB/LAN/GPIB Interfaces Connectivity Guide. If you have
installed the IO Libraries Suite, you can access the connectivity guide via the
Keysight IO Libraries Control icon. Alternatively, you can access the connectivity
guide via the Web at www.keysight.com/find/connectivity.

USB

The USB interface requires no front panel configuration. USB operation and
configuration is supported by the version of VISA and SICL IO libraries on your PC.
Before connecting the USB cable, ensure that the I/O software is installed in
NOTE
your computer.
See
Keysight IO Libraries software. If you have installed other I/O software, refer to
documentation that accompanies the software.
Keysight N1913/1914A Installation Guide
to install, use the Automation-Ready CD with Keysight IO Libraries Suite which
is shipped with the power meter.
information and install this application via the Web at
www.keysight.com/find/iolib.
www.keysight.com/find/iolib.

"Remote Interface Configurations"

Getting Started
on page 39 for information about
1
39