Figure 1-3 Lan Network Restart Pop-Up - Keysight N432A Installation Manual

If your LAN does not support DHCP, refer to the connectivity guide.
NOTE
4 Press
5 Press
Figure 1-3
6 Press
7 If you intend to program over the LAN interface, make sure that you have
8 Use the Connection Expert utility of the IO Libraries Suite to add the N432A
If you have installed other I/O software, refer to the documentation that
NOTE
accompanies the software.
9 You can use various programming environments to control the N432A. For an
Keysight N432A Installation Guide
Network DHCP
Restart Network
A pop-up message will appear for 5 seconds as shown below. Monitor the
Status at the bottom of the display to determine when the server has assigned
an address.
LAN network restart pop-up
, to return to a measurement screen.
installed the I/O software on your PC.
and verify the connection. When identifying the N432A, it is easiest to use the
IP address that you noted in step 5 above.
overview on programming the N432A via LAN, refer to the connectivity guide
and the programming guide.
if you need to configure any optional settings.
.
Getting Started
43
1