Analyzer Options; Option 110, Transmission Measurement; Option 111, Quickcal; Option 230, 4 Ghz Spectrum Analyzer - Keysight N9912A Service Manual

General Product Information

Analyzer Options

Analyzer Options
Below is a list of options available for the FieldFox N9912A at the time of initial
product release. Additional options will be added as product features are
enhanced. Go to
currently available upgrade options.

Option 110, Transmission Measurement

This option allows use of the second port in either the NA (network analyzer) or
CAT (cable and antenna test) modes for transmission measurements.

Option 111, QuickCal

This option provides a calibration that is performed automatically using
calibration standards that are built-in to the N9912A. Calibration standards are
automatically switched in as needed. QuickCal is ideal for making quick DTF
and cable loss measurements without taking the time to perform a full O,S,L
Cal.

Option 230, 4 GHz Spectrum Analyzer

This option allow the N9912A to make spectrum analyzer measurements from
100 kHz to 4 GHz. This option can be installed only on a 4 GHz unit.

Option 231, 6 GHz Spectrum Analyzer

This option allow the N9912A to make spectrum analyzer measurements from
100 kHz to 6 GHz. This option can be installed only on a 6 GHz unit.

Option 235, Preamplifier for Spectrum Analyzer

This option adds a preamplifier to the input port for spectrum analyzer
measurements.

Option 302, External USB Power Sensor Support

This option allows the use of an external USB controllable power sensor.

Option 303, Network Analyzer Capability

This option allows the N9912A to make one-port network analyzer
measurements. For two-port network analyzer measurements, add Option 110.
Keysight N9912A Service Guide
www.keysight.com/find/fieldfox2 for information on
2-3