Avaya Communication Manager Administrator's Manual page 781

Channel Numbering
The ETSI and ISO QSIG specifications require that B-channels on an E1 be encoded as 1-30 in the
Channel ID IE. Prior to the existence of this field, Avaya Communication Manager only used this scheme
for Country Protocols 2a (Australia) and 13a (Germany 1TR6). This field appears when the
Mode field is isdn-pri, the
peer-master or peer-slave.
Valid entries
timeslot
sequential
Connect
In order to control communications at layers 2 and 3 of the ISDN-PRI protocol, use this field to specify
what is on the far end of this DS1 link. This field only appears when the
isdn-pri.
Valid entries
pbx
line-side
network
host
Administrator's Guide for Avaya Communication Manager
November 2003
Bit Rate field is 2.048, the
Usage
If Avaya Communication Manager is connected via QSIG trunks to
a switch/server supporting the ETSI QSIG or ISO QSIG
specifications, this field must be sequential.
When the Signaling Mode
2.048, but the Channel Numbering
of the setting of other fields, it is set internally to sequential for 2a
(Australia) and 13a (Germany).
Usage
Enter pbx if this DS1 link is connected to another switch in a private
network. If pbx is entered, the
Enter line-side when Communication Manager is acting as the
network side of an ISDN-PRI interface. Use line-side to connect to
Roll About Video equipment.
Enter network when the DS1 link connects Communication
Manager to a central office or any other public network switch.
Enter host when the DS1 link connects Communication Manager to
a computer.
Connect field is pbx, and the
field is isdn-pri and the Bit Rate
field does not display because
Signaling Mode
Interface field appears.
Screen Reference
DS1 Circuit Pack
Signaling
Interface field is
field is
field is
781