Avaya Communication Manager Administrator's Manual page 759

BRI LINK/MAINTENANCE PARAMETERS
Country Protocol
Used with World Class BRI Data Modules. Enter the protocol that corresponds to your supported
initialization and codesets. The Country Protocol must match any previously-administered endpoint on
the same port. The following table lists the valid protocol entries.
Country/Area
Australia
ETSI (Europe)
Japan
Singapore
United States (Bellcore National ISDN)
Endpt ID
Used with World Class BRI Data Modules. Appears only if the
for multipoint configuration conformance to the Bellcore Terminal Initialization procedures. In these
procedures, a multipoint configuration requires that the last 2 digits of the Service Profile Identifier
(SPID) be between 00 and 63 and be binary unique for each endpoint. This field, combined with the
SPID, gives the effective SPID administered into the terminal. Bellcore ISDN-1 requires that the SPID
programmed into the endpoint contain at least 9 digits. (For example, if the
field is set to 01, then the SPID administered on the terminal is 000123401. The three leading
Endpt ID
zeros are necessary to create a 9-digit SPID.)
Valid entries
through
00 62
Endpt Init
Used with 7500 and World Class BRI Data Modules. Endpoint initialization is a procedure, required for
multipoint operation, by which User Service Order Profile (USOP) is associated with an endpoint on the
ISDN-BRI. This association is made via the Service Profile Identifier (SPID), administered into the
system and entered into the ISDN-BRI terminal. For a ISDN-BRI terminal to become operational in a
multipoint configuration, both the administered SPID and the SPID programmed into the ISDN-BRI
terminal must be the same. This means that the SPID of the new or re-used terminals must be
programmed to match the administered SPID value.
Valid entries
y/n
Administrator's Guide for Avaya Communication Manager
November 2003
Usage
Enter a 2-digit number. Each
value for each endpoint on the same port.
Usage
Indicates the terminal's endpoint initialization capability.
Protocol
2
etsi
3
6
1
field is y. This field provides
Endpt Init
SPID
Endpt ID field must have a unique
Screen Reference
Data modules
field is 1234, and the
759