Avaya Communication Manager Administrator's Manual page 739

Characters
3
4-5
6-7
NOTE:
You can enter X in the
port assignment (also known as
stations are referred to as "phantom stations." If this data module is designated as a
secondary data module (Secondary data module set to y) X cannot be entered into this
field. The port of a primary data module cannot be changed to X if a secondary data
module is administered.
Remote Loop-Around Test
Used with Processor/Trunk and X.25 Data Modules. Appears when the
Valid entries
y/n
y/n
Administrator's Guide for Avaya Communication Manager
November 2003
Meaning Value
Carrier A through E
Slot Number 0 through 20
Circuit Number 01 through 04 (x.25 circuit pack)
01 through 31 (DEFINITY SI, S8700
IP-Connect (tdm, pdm) configurations)
01 through 16 (ppp for S8700
IP-Connect)
01 through 08 (system-port for S8700
IP-Connect)
17/33 (ethernet on S8700 IP-Connect)
field to indicate that there is no hardware associated with the
Port
Usage
For Processor/Trunk Data Modules, enter y if the data module
supports a loop-back test at the EIA interface. In general, Avaya
equipment supports this test but it is not required by Level 2 Digital
Communications Protocol. Enter n to abort a request for this test.
For X.25 Data Modules, enter y to allow remote loop-around tests
on this port. See the Maintenance for Avaya Communication
Manager and DEFINITY® Server manual for your model for more
information about remote loop-around tests. Enter n to abort a
request for this test.
Administration Without Hardware
Type
Screen Reference
Data modules
(AWOH)). These
field is pdm, tdm, or x.25.
739