Show Policy Server Rules - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show policy server rules

Displays the names of policies originating on a directory server that have been downloaded to the switch.
show policy server rules
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command displays information about policies created on directory servers only.
Commands," for information about configuring and displaying policies directly on the switch.
Examples
-> show policy server rules
Num name
---+-------------------+-------+-------------+------------
1 QoSRule1
2 QoSrule2
Fields are defined here:
output definitions
Num
name
prio
scope
status
page 40-12
prio scope
0 Provisioned
0 Provisioned
An index number corresponding to the policy rule.
The name of the policy rule; only rules configured through PolicyView
are displayed in this table.
The priority or preference of the rule. Indicates the order in which rules
will be checked for matching to incoming traffic. If two or more rules
apply to the traffic, the rule with the highest preference is applied. Pref-
erence is determined when the rule is created.
The type of rule. Provisioned is the only type valid currently.
The status of the rule: Active indicates that the rule has been pushed to
the QoS software in the switch and is available to apply to traffic;
notInService means the rule may be pushed to the QoS software in the
future but is not available yet (typically because of a variable validity
period); notReady indicates that the rule will never be pushed to the
QoS software because its validity period has expired or because it has
been disabled through SNMP.
OmniSwitch 6250 CLI Reference Guide
Policy Server Commands
Chapter 38, "QoS
status
Active
Active
November 2009