Ipv6 Bgp Neighbor Update-Source - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

BGP Commands

ipv6 bgp neighbor update-source

Configures the local IPv6 interface from which a BGP peer will be connected. This local IPv6 interface
can be configured for internal and external BGP peers.
ipv6 bgp neighbor ipv6_address [update-source interface_name]
no ipv6 bgp neighbor ipv6_address [update-source interface_name]
Syntax Definitions
ipv6_address
interface_name
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
The BGP peer is restarted after issuing this command.
•
If a BGP peer is configured with its link-local address, use the update-source parameter to specify the
name of the IPv6 interface from which this peer is reachable. This is required to establish a BGP peer-
ing session.
Examples
-> ipv6 bgp neighbor 2004::1 update-source bgp_ipv6
-> no ipv6 bgp neighbor 2004::1 update-source bgp_ipv6
Release History
Release 7.1.1; command was introduced.
Related Commands
show ipv6 bgp neighbors
ipv6 interface
MIB Objects
alaBgpPeer6Table
alaBgpPeer6Addr
alaBgpPeer6LocalIntfName
OmniSwitch CLI Reference Guide
The 128-bit IPv6 address for the BGP peer.
The name of the local IPv6 interface that provides the TCP connection
for this BGP peer.
Displays the configured IPv6 BGP peers.
Configures an IPv6 interface on a VLAN or IPv6 tunnel.
March 2011
ipv6 bgp neighbor update-source
page 19-225